The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**amcgeh01** · 10-19-2019, 09:23 PM

Thank You Richard... That helps alot, I did not even realize I was missing such a large square hole although I was expecting it to be round. My guess was way off but at least I have something to go by.

I was reviewing the install instructions on their site for the inline tube setup and they mentioned I would have to reuse the "Tension Rod and the Hook"..? Would you happen to have those 2 parts..? I still need to figure out where they go and attach points but the drawing they have is useful but not super clear.

10-19-2019, 09:23 PM	#3
amcgeh01 Senior Member Join Date: Jul 2009 Location: SoCal Posts: 206	Re: Where to Drill..? Emergency Brake Thank You Richard... That helps alot, I did not even realize I was missing such a large square hole although I was expecting it to be round. My guess was way off but at least I have something to go by. I was reviewing the install instructions on their site for the inline tube setup and they mentioned I would have to reuse the "Tension Rod and the Hook"..? Would you happen to have those 2 parts..? I still need to figure out where they go and attach points but the drawing they have is useful but not super clear. __________________ ******************************************** In-work on my 5.3L/4L65E/NP208 case conversion into a 1972 GMC JImmy 4x4... Not as simple as it looks folks..