The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**FirstOwner69** · 04-09-2020, 04:31 PM

In response to post 1...

Your truck appears to be a 67-70. If so, I don't recall any additional mounting plate. I believe they were only used on the 71s and 72s which used a hanging pedal and throttle cable to the carb rather than a floor mounted pedal and rod.

Frankly, mine has never been removed from the truck, but based on the pictures and my recollection (I'm not near my truck to verify) this assembly is inserted from the engine side of the firewall. Below is a repeat of the second picture in post 2. The yellow markings show the heads of what appear to be hex head sheet metal screws. The blue arrow is directed at the top part of the accelerator assembly.

EDIT: The blue arrow to the left is very hard to see. Also, the camper harness wiring over the bracket is probably not on your truck.

04-09-2020, 04:31 PM	#5
FirstOwner69 Senior Member Join Date: May 2010 Location: Wisconsin & Arizona Posts: 4,839	Re: Help with pedal install In response to post 1... Your truck appears to be a 67-70. If so, I don't recall any additional mounting plate. I believe they were only used on the 71s and 72s which used a hanging pedal and throttle cable to the carb rather than a floor mounted pedal and rod. Frankly, mine has never been removed from the truck, but based on the pictures and my recollection (I'm not near my truck to verify) this assembly is inserted from the engine side of the firewall. Below is a repeat of the second picture in post 2. The yellow markings show the heads of what appear to be hex head sheet metal screws. The blue arrow is directed at the top part of the accelerator assembly. EDIT: The blue arrow to the left is very hard to see. Also, the camper harness wiring over the bracket is probably not on your truck. Attached Images __________________ Jim Last edited by FirstOwner69; 04-09-2020 at 06:43 PM.