Re: vintage air question
I did my install a few years ago, but I definitely went off of the reservation on how I did it. I completely smoothed the firewall.
I upgraded to what they call the fender well kit which adds to the length of hoses. I ran my hoses through the right kick panel vent and the far right side of the firewall. It was not an easy install, but I like the look.
I also upgraded to the EZ Clip hoses which allow you to cut and make your own hoses. The EZ Clip lines are a smaller diameter than the regular ones. You must buy an EZ Clip crimping tool.
I did the complete install then took it to one of Vintage Air's local dealer/service shop and had them evacuate and charge the system.
I also installed electric cooling fans and Vintage Air's heavy duty wiring harness.
All in all I am very pleased with the system.
|