Quote:
Originally Posted by mongocanfly
How close is the diff to the floor?..even if you did c-notch it may be the 1st part to hit...
You could remove the bump stop and relocate it over and up to give you a little more travel...
You might also want to consider a mini c and boxing the frame around it...
|
Right now .... full weight on jack .... the diff is round 3" from floor
The bumpstops are 2.5" tall. And they have about 0.25" before they start to make contact. Giving around 2.75" total from frame to axle if not bumpstop.
So wondering how to add a couple inches best. I dont mind a small rake.
2" lift blocks ?
Airbags.
New leafs - this says 2.5" lift
https://www.sdtrucksprings.com/index...ducts_id=17900
etc