View Single Post
Old 02-15-2017, 07:21 PM   #116
joedoh
Senior Member
 
joedoh's Avatar
 
Join Date: May 2007
Location: Doodah Kansas
Posts: 7,746
Re: 1941 project fenix

tore everything back apart for final assembly


trans crossmember out to finish weld


had to flip the cross shaft on the uppers to the standard camber side. dont try this with stock springs, but with drop springs, no danger.


picked up the de-arched leafs, went 3.5 to counter the larger tire I always run on the rear. Last time I de-arched 1" and used 3" blocks, this time I figure do it all with spring.


picked up the seats while I was on that side of town. Look ok, not at all like we talked about in the beginning. I was pretty upset when I picked them up, I have calmed down a bit.


edit: after dinner I got to decide between welding or assembly, I chose assembly. there is $350 in new parts in this photo!
__________________
the mass of men live lives of quiet desperation


if there is a problem, I can have it.

new project WAYNE http://67-72chevytrucks.com/vboard/s...d.php?t=844393

Last edited by joedoh; 02-15-2017 at 11:45 PM.
joedoh is offline   Reply With Quote