[DD1]

Spent some time test fitting and lining up the A pillar today. I think I have it in a place where I will be able to work it into shape following Mike's advice. After I took these pics, I finished prepping the part and the lower cowl panel. Put weld through primer where I thought it was most needed, and almost painted over the white marks I made to line up the part. (I actually did paint over them, but caught it in time to wipe enough paint off).

Used a step drill and a Dremel grinding wheel to shape the hings bolt holes a bit better than what's pictured. Plug welded a few holes on the firewall / floor and that's about it for today. I was supposed to be working on the truck all day today because Sunday the wife and I were going to the Rhinebeck Car Show / Swap Meet like we do every year. Of course it's supposed to rain Sunday, so I went alone today instead. Hopefully I will be able to get the A pillar done tomorrow.