Thanks Jim!
Happy New Year to everybody!
Had a visit by the shop this week from cousin JB, who works at Interiors by Shannon in Alabama. He was up for the holidays. They have recently picked up a bead roller so we did some practice runs on pre-stretched and non-stretched beads, and then some beads using the Lennox Nibbler. Finished up with some shrinking on the MH-19. We ran out of time to punch louvers. Great to see him again, nice to spend time "playing" in the shop.
Progress on the console this weekend... Mike is still in California visiting family, so Jake and I have been texting pics to him of what he's missing haha..
Corner number two, we've already shown some shrinking, so no we'll show stretching the inside corner..
Placing the part on a suitable flat anvil, a barrel roll hammer is used to provide stretch the inner corner...
You get to a point where flat is no longer useful, so then we use another anvil, this one in the form of a square tube. Works well for what we're doing here...
Fitted and welded....
Next, a pattern made of the rear hump for trimming the console.. we'll keep it snug for now for placing anchors and then trim later for carpet and sound deadening space.
Standoffs used for anchors, trimmed to fit angle of the hump... and welded in place. Crossmember made for inside the console and spot welded in.
