Roof Seam - Welded up
While I worked on my rocker panel I finished cleaning out the seam sealer on the roof panel. You can't get it all out that's for sure. So I'm pretty sure I have a few contaminated welds in there... I used a wire wheel to get the majority out of the seam, then I used a sharpened chisel to get the rest out. I found that the seam sealer that was sunken down in between the panels would heat up and rise to the surface after a few welds so I would take the chisel and keep scraping it out when it surfaces as I welded the seam.
I'm so close I can taste it.... Here is my list of items left to body work:
1. Drivers cab corner
2. Gas filler hole
3. Rear window seam(very small section of rust)
4. Firewall holes and smoothing.