Quote:
Originally Posted by Advanced Design
Here is section 1 sheet 42. Jim good thinking on the factory assembly manual.
|
Perfect!! Evidently, I should be buying one of those... I think my truck was built on a Friday shift, there's about 7 spot welds per brace
I've decided on the rear panel. I'm going to make a replacement section for the bottom 1" or so (excepting the one area where I need to go about 5" high for about 5" of width). There's just too much pitting on the old lip for me to be comfortable with reusing it. Fortunately I can cut a piece that wide from an old '71 hood I have leaning against the garage
The rest of the panel is sound, just denty. I can't seem to get a good picture of it, though.
__________________
CURRENT
'50 GMC 100 shortbed Gen IV 4.8 LS - 4L65E (Secret truck, Shhh!!!)
Build
'63 Buick Wildcat Coupe 401ci Nailhead (Very much in pieces)
Photos
'66 Impala SS convertible 327-QJet-glide (4 speed swap one of these days...)
Photos
'69 CST/10 4x4 SWB Stepper 350 2bbl - NV4500/NP241C (Broken Truck!)
'72 Sierra Grande 2WD LWB fleetside 350-TH350
Refresh
'99 K2500 Silverado RCLB 5.7 Vortec - NV4500/NP241C (Daily)
'99 K2500 Suburban 7.4 Vortec - NV4500/NP246 (still working out the bugs)
SOLD
'71 Custom/10 2WD LWB fleetside -
'72 GMC K/3500 Dually (Sold to redryder)