[66Project]

Got a lot done this weekend. Finished painting the frame and got it back on jack stands. Started putting on the suspension components that was rebuilt a while back. The disk brake suspension is off of a 87 Chevy truck. 3" drop spindles with slam specializes SS7. I like these because they use an internal bump stop. Air ride is a first for me so its going to be a learn as I go kind of an event.











Aired out...
Sits pretty low. Not exactly what I was going for but I like it. The bracket kit I got for the front had cups that bolted to the bottom of the bag and sits in the lower control arm spring pocket. They looked too tall at first so i took about two inches out of the 3 inch cup. That may have been a mistake because it looks like the air bag's lower bellow is making contact with the sides of the control arm spring pocket. I'm going to weld back on what I cut off and see where that lands me.