Re: Rodstored-72's 1986 DD build
I remembered that I did take a picture of the new ECM mounting plate. I used the factory jack holes. the alum plate is rounded on the corners and just fits the ECM. I cleaned and painted the plate "chrome". I attached rubber stand offs to "raise" the alum. plate off of the fender well. utilizing 1/4x20 bolts and nutserts (rivnuts?). the ECM is mounted using the factory 4 holes and again I used 4 rubber standoffs to raise it above the plate mounting nutserts. the ECM mount screws are 10-24 and also used nutserts. overall it is a cleaner mounting situation as well as more sturdy too.
enjoy!
|