[First c10]

I have been looking at the bed and taillight area where I want the fuel filler. I made the flip down door a while back but decided to start cutting away today since it is not going to install itself.
I was able to cut out the pocket and make the plate to mount the filler neck to.
It was a lot of work since I had not done this mod before. But I bet I have 20 hours in the door and filler neck mount so far. The plate is not welded in yet.
So about 2 hours and it should be completed.
I did order some 1.75" stainless steel fittings to run from the filler neck to the tank.

I am going to put the bed on and plumb the filler pipe before I finish welding up the filler cap mount.