Quote:
Originally Posted by ricott
To answer your Drive by wire/Drive by cable question, it is A very simple swap. All you really have to do is replace throttle bodies. You take the 3 bolts holding the throttle body off and slip on the Drive by Cable Throttle body. You will also need the correct wiring harness - the Drive by Wire connectors that plug into the computer are red and GREEN. the Drive by Cable Harness ends are Red and BLUE. If you are doing an auto, it is super easy to wire one of these up using a truck harness. Once you get it going, I can promise that you will NEVER go back to the earlier chevy engines. Good luck.
|
Thank you sir. Sounds simple enough. Any suggestions on someone to tune the ECU/TCU if I go the 4L60E route? I'm pretty sure I can trim all of the unneeded wires, I just need someone to workover the computer.