The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Crash_OK · 12-03-2011, 09:56 PM

Decided to clean the engine up a little, even though I will not be using it on this project.

Picked up a used press for the differential rebuilds. It will also be used on the ball joints, spring bushings, etc.

Picked up some cheap tools from Harbor Freight.

Built up the 12 bolt today

Tomorrow, I will start on the DANA 44 rebuild if I can found some inner axle seals. If not I may get the sand blaster rigged up and clean up the shop. I bought a used Texas Blaster Yesterday.

I have never used one before, so I am open to any ideas on how use it.

12-03-2011, 09:56 PM	#22
Crash_OK Registered User Join Date: Nov 2011 Location: Edmond, OK. Posts: 1,362	Re: Crash's 72 K10 Decided to clean the engine up a little, even though I will not be using it on this project. Picked up a used press for the differential rebuilds. It will also be used on the ball joints, spring bushings, etc. Picked up some cheap tools from Harbor Freight. Built up the 12 bolt today Tomorrow, I will start on the DANA 44 rebuild if I can found some inner axle seals. If not I may get the sand blaster rigged up and clean up the shop. I bought a used Texas Blaster Yesterday. I have never used one before, so I am open to any ideas on how use it. Last edited by Crash_OK; 12-03-2011 at 10:06 PM.