Thread
:
Crash's 69 K10
View Single Post
12-10-2011, 10:25 PM
#
25
Crash_OK
Registered User
Join Date: Nov 2011
Location: Edmond, OK.
Posts: 1,362
Re: Crash's 72 K10
Installed all new bearings and setup the differential on the DANA 44 today. I created setup bearings for the carrier bearings and a setup race for the inner pinion race. This made the process much easier. Unlike the 12 bolt that I setup last week, the DANA took multiple iterations to get the pinion depth and backlash correct. Unfortunately I did not take time to get pictures of the setup.
After I buttoned the differential up, I started on the ball joints.
Knuckles installed
Left Hub and rotor installed.
I couldn’t do the right hub, there was some damage from some event in the past.
I am considering going with a disc brake setup in the rear. Not sure yet, but will research it some tonight. Tomorrow, if it warms up enough I will do some painting on the axles, if not I will get rigged up for sand blasting.
Crash_OK
View Public Profile
Find More Posts by Crash_OK