[crv]

@ D.PASSMORE - I was planning on using their header/snap bar until I saw how little the snaps were threaded into it. I ended up taking all of their snaps out and clamped it to the fiberglass header to use as a template to drill the holes for snaps which I then riveted on the fiberglass header. For my mounting holes, I cut the heads off a few bolts and ground a point on them to transfer my holes on each end of the windshield frame. Drilled those and marked and drilled for the two center mounts as well.

@Rob - I think I may have goofed up a little. I'm going to attach pics so you can see, but my header isn't sitting down on each side...unless my windshield frame differs some from your mold. I'm going to try and see if I can get it to fit a little better.