Re: Wampus Cat
I decided to attach the new Drip Rails with some of the panel bonding adhesive that I had left over from attaching the outer roof rather than spot/plug welding. (Evercoat FIB-816 Maxim Large Panel Bonding Adhesive (see entry #43 above).
I think this product creates a very strong bond while also completely sealing and filling the area between the drip rail and the A-pillar to prevent future water incursion and rust.
I cut some scrap wood in to a 3/4" wide by 1/2" thick piece to use as a backing piece for clamping while bonding. I used duct tape (with flames of course) to cover the wood backing piece so that it would not stick to any bonding adhesive that oozed out during clamping. I also used the duct tape to mask areas where I did not want excess adhesive to stick.
Clamped it in place for a 24 hour cure, then removed the clamps and trimmed away any excess adhesive with an Exacto knife.
Now just need work on the passenger side.
.
|