The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

kustombrad · 01-20-2009, 02:56 PM

Thanks! I always tried to keep exhaust at least an inch from anything too critical. On this one it will be a little different. Since it was a 3" system, room went away REAL fast. I'll end up wrapping this one in the close areas by the trans, master cylinder and frame. It's about an 1 1/2" away from any part of the fuel tank, so no worries there. I'll also end up covering the trans cooler lines when I run them, so they stay cool also. Hope that helps. By the way... You have a VERY nice truck!!!

01-20-2009, 02:56 PM	#33
kustombrad Registered User Join Date: Nov 2008 Location: So. Cal. Posts: 452	Re: Project "49 No Buck$" Thanks! I always tried to keep exhaust at least an inch from anything too critical. On this one it will be a little different. Since it was a 3" system, room went away REAL fast. I'll end up wrapping this one in the close areas by the trans, master cylinder and frame. It's about an 1 1/2" away from any part of the fuel tank, so no worries there. I'll also end up covering the trans cooler lines when I run them, so they stay cool also. Hope that helps. By the way... You have a VERY nice truck!!! Last edited by kustombrad; 01-20-2009 at 03:00 PM.