The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

chevyman95 · 10-26-2010, 08:42 PM

Haha thanks guys, kind of feeling like I might have bit off more than I can chew though. This is my first time welding and doing metalwork. The floor pan I bought doesn't even come close to fitting. I am thinking about just making my own, seems easier at this point. I am also not doing the whole rocker, just the part that is rusty. Sure it would be better to do the whole thing but the ends aren't bad at all and I'm kind of worried about screwing it up at this point. I practiced welding today and got to the point where I feel confident moving forward on the truck. So we will see how it goes.

10-26-2010, 08:42 PM	#22
chevyman95 Registered User Join Date: Mar 2010 Location: Underground Bunker Posts: 284	Re: Chevyman's under $1000 budget project Haha thanks guys, kind of feeling like I might have bit off more than I can chew though. This is my first time welding and doing metalwork. The floor pan I bought doesn't even come close to fitting. I am thinking about just making my own, seems easier at this point. I am also not doing the whole rocker, just the part that is rusty. Sure it would be better to do the whole thing but the ends aren't bad at all and I'm kind of worried about screwing it up at this point. I practiced welding today and got to the point where I feel confident moving forward on the truck. So we will see how it goes.