|
Re: Fashionable Fever! - 1969 Chevy C10 Build
I started back up on my drivers side outer fender. Not sure why this portion of fender was all smashed in. All I know is it's gonna be a lot of work to fix it. I got the spot welds drilled out and cut the piece out so I could hammer the dent from the back. It was all dented in where it still shows dirty paint.
I actually got the piece pretty well straightened out. I also had to straighten a bit of the outer fender since it too was bent in the same spot. I got to the point of welding it in, but my welds are forming/creating lots of spatter and are turning out very porous. So that's taking a lot of time to figure that out. It's almost like my tank is empty, but my gauge is reading 1000 psi. Tomorrow I will investigate it further. It would be nice to get it all put back and maybe lay down a layer of bondo.
|