The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Dr Jekyll · 11-17-2020, 04:00 PM

Yes, you must unthread the the block with the hooks on it from the the threaded rod. Then the block with hooks is positioned on the spring. I’m pretty sure it slid in from the side. The threaded rod then slides through the lower control arm and is threaded back into the block with hooks. I had the same problem with it not fitting through the control arm. Get er dun

11-17-2020, 04:00 PM	#22
Dr Jekyll Registered User Join Date: Mar 2020 Location: Quinlan, TX Posts: 84	Re: 1969 Chevy C10 Yes, you must unthread the the block with the hooks on it from the the threaded rod. Then the block with hooks is positioned on the spring. I’m pretty sure it slid in from the side. The threaded rod then slides through the lower control arm and is threaded back into the block with hooks. I had the same problem with it not fitting through the control arm. Get er dun __________________ “Hammer to fit, paint to match.” My 70 C10 frame off 3d wheel and paint mock up? Last edited by Dr Jekyll; 11-17-2020 at 04:50 PM.