The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**1971Stepside** · 07-26-2019, 03:49 PM

I have the holes in my cross member for the exhaust and went with the Dingo trans cross member so didn't have to jump up right at the header, but it looks like I will have to go up just beyond that. I would like the headers to be about 2" higher. I'm sure interested in the kit you ordered though. Trying to decide if I want to do this or just take it to a shop. Are you going to H-Pipe it behind the trans?

07-26-2019, 03:49 PM	#264
1971Stepside Almost Satisfied Join Date: Mar 2002 Location: Springfield, MO Posts: 2,930	Re: TA_C10: Stage 1 I have the holes in my cross member for the exhaust and went with the Dingo trans cross member so didn't have to jump up right at the header, but it looks like I will have to go up just beyond that. I would like the headers to be about 2" higher. I'm sure interested in the kit you ordered though. Trying to decide if I want to do this or just take it to a shop. Are you going to H-Pipe it behind the trans? Attached Images __________________ 1971 C10 Stepside. LSx 6.0 with BTR Stage IV, Speed Engineering Headers, 4L80e transmission w/3200 Circle-D Stall. 3.73. Posi. Purchased this truck when I was 17. I started the rebuild (or take apart) in 1993. I have drug it around all over the country in pieces. Finally back on the road in 2021. "I can't complain, but sometimes I still do. Life's been good to me so far."