The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - T56 crossmember What did you use in your swap?

lutronjim · 07-20-2020, 09:33 PM

Don't know how close Blazer is to C10 but I got my mounts from an outfit caused MuscleRods. I have an LC9 which has variable timing in front making it a 'long' engine - close to radiator and firewall. I bought front and tranny mounts as a kit. They have since changed design since I bought mine - see http://www.brphotrods.com/products/6...uck/index.html.

My set worked fine - stock LC9 pan - everything close but nothing hits. Correct angle for drive shaft.

I also purchased stainless headers from them. It doesn't hurt that they are are 'bout 30 minutes from house.

Hope this helps.

07-20-2020, 09:33 PM	#2
lutronjim Registered User Join Date: Dec 2013 Location: Dunwoody,Ga Posts: 443	Re: T56 crossmember What did you use in your swap? Don't know how close Blazer is to C10 but I got my mounts from an outfit caused MuscleRods. I have an LC9 which has variable timing in front making it a 'long' engine - close to radiator and firewall. I bought front and tranny mounts as a kit. They have since changed design since I bought mine - see http://www.brphotrods.com/products/6...uck/index.html. My set worked fine - stock LC9 pan - everything close but nothing hits. Correct angle for drive shaft. I also purchased stainless headers from them. It doesn't hurt that they are are 'bout 30 minutes from house. Hope this helps.