|
Re: '76 K25 brake issue
Quote:
Originally Posted by c30
You won't find a rebuild kit but here is what I did.
I want my truck to look as original as possible. When replacing the master cylinder, it seems all I could find was a big ole squared off looking thing that did not look at all like the original. Had a single bolt on cap instead of the two wire bales.
Knowing that the bore of my original was 1", I think, I ordered a master for the correct application with the same size bore. I disassembled both, honed out the original to clean it. Then reassembled the old master with the new innerds and it's been doing fine.
|
Creative 'end around' solution. Kudos for thinking outside the lines.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|