[Mulk]

Continued...... I can only post 3 pictures at a time???

Once all the rivets and bump-stop are removed, you can start making your marks for the cut. I would suggest making a template of the outside of the c-notch plate. I will be MUCH easier that holding the heavy piece in place while you mark everything (SOOOO wish I would have done that)

1st Photo..... Spend the money on a quality bit. You will be VERY happy you did. I drilled everything with just this 1 bit

2nd Photo.... It said to line the front edge of the plate to the elongated hole in the frame, above the coil-spring mounting area.

3rd Photo..... Just showing how I used welding magnet to help line-up plate. But if you make a template, you won't have to struggle with this step.