[tubbedII]

During this whole tear down, there was A LOT that needed to be done, but unfortunately, not may pictures were taken.

With only having 1 compressor, the fill time was way too slow for my likings, so I put together a York 210 I got out of a Volvo, and am using that a EDC. The downfall for me is that I do not have a welder and cannot weld, so I'm stuck with looking for bolt in parts. I found a bracket for the york online for a SBC from a 4x4 guy. Bad part was, it it the master cylinder. I then had to swap out the master/booster for another that had a bracket which moved it about an inch higher.

The brake lines on the ride were basically just there to get the truck sold, so all new lines were purchased as well as new tranny lines to the radiator. I put new TA bushings in the rear and rebuilt the rear drums while cleaning it all up.

That pretty much gets me up to speed where I am today. There's other things, but I'll snap some pics in the day light so I can post them as well.