The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Hooker Blackheart 1967-72 C10 Truck LS/LT Swap System Info Thread

**Jason Banks** · 01-02-2020, 07:24 PM

I'm glad EddyC brought this back up to the top. I didn't see this thread when it was started.

Just yesterday I discovered the engine mounts I got from another source didn't line up very well with my frame and crossmember. I also discovered their trans crossmember is tight up to the inside of the frame on both sides, which doesn't leave room to run wiring and brake/fuel lines inside the frame.

I really like the design of these engine mounts since they mount in the holes that are further back on the top of the frame and the back hole on the crossmember. Not sure why other designs mount forward and then cantilever back.

Looks like if I order today I can pick them both up at Summit in Arlington on the 7th.

01-02-2020, 07:24 PM	#64
Jason Banks Senior Member Join Date: Dec 1999 Location: TX Posts: 1,520	Re: Hooker Blackheart 1967-72 C10 Truck LS/LT Swap System Info Thread I'm glad EddyC brought this back up to the top. I didn't see this thread when it was started. Just yesterday I discovered the engine mounts I got from another source didn't line up very well with my frame and crossmember. I also discovered their trans crossmember is tight up to the inside of the frame on both sides, which doesn't leave room to run wiring and brake/fuel lines inside the frame. I really like the design of these engine mounts since they mount in the holes that are further back on the top of the frame and the back hole on the crossmember. Not sure why other designs mount forward and then cantilever back. Looks like if I order today I can pick them both up at Summit in Arlington on the 7th.