[reaper71]

Update:

I got back on the radiator support/fender support.
I put the hood on to check the fitment and noticed the fenders needed to come up.
So what I did to make this happen was by using a ratchet strap across the tops of the fenders to pull them together, then using some angle iron across the front of the Rad. support I clamped it in place.
Removed the strap to close the hood to check fitment.

Pic 1. The angle iron welded in place to make it super ridged. I also installed the stock fender braces to tie it all together.

Pic 2. Hard to see it but I also welded in a spine along the lower section to help with flex.