The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - "BETSY" - 1964 C-10 Longbed / Step Side

Bomp · 03-03-2013, 10:58 PM

On the rusted bolt I use PB Blaster, shoot it and use a screw driver to pick out as much dirt as possible.
Re-shoot 2-3 times a day til it gives.
Unless my patients wear thin then I use a propane torch to heat it up.
Then it either gives or snaps off.
I6 vs v8 depends on what your wanting to do.
Personally I prefer v8's but thats just me. I may end up using an I6 on Bompenstein.
On patch panel.
Page 5 on my build I'm working with patch panel and home made patch panel pieces.

Here are some builds that may interest you.

http://67-72chevytrucks.com/vboard/s...d.php?t=457465

http://67-72chevytrucks.com/vboard/s...d.php?t=474858

Here ya go. Looking good.

03-03-2013, 10:58 PM	#7
Bomp Registered User Join Date: Apr 2011 Location: . Posts: 3,104	Re: "BETSY" - 1964 C-10 Longbed / Step Side On the rusted bolt I use PB Blaster, shoot it and use a screw driver to pick out as much dirt as possible. Re-shoot 2-3 times a day til it gives. Unless my patients wear thin then I use a propane torch to heat it up. Then it either gives or snaps off. I6 vs v8 depends on what your wanting to do. Personally I prefer v8's but thats just me. I may end up using an I6 on Bompenstein. On patch panel. Page 5 on my build I'm working with patch panel and home made patch panel pieces. Here are some builds that may interest you. http://67-72chevytrucks.com/vboard/s...d.php?t=457465 http://67-72chevytrucks.com/vboard/s...d.php?t=474858 Here ya go. Looking good.