[Osker]

Measure twice, cut once. I did not do that and wound up with a big gap. Luckily, I had the rest of the panel and was able to cut out the patch and keep practicing……

I can definitely see the value in using a full floor pan to speed up the work and minimize the welds. If I keep this cab, it will get a full floor. The time I spent on stitching just the driver’s side up and knowing I would have to correct the passenger side - it would make sense for me to do a full floor.

I got the floor pan in tacked and then stich welded and that was satisfying but there were fitment issues with the corner by the accelerator pedal and firewall. I called it good knowing I was pulling the cab off for covered storage and it was solid enough to lift off the frame without flexing and distorting.