The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

rodstored-72 · 07-21-2020, 06:46 PM

bigmoe, thank you for the reply. I have the pedal pigtail (about 6-8" long) and the wires from the ECM (per pin nos.) I also have the diagram that shows each end. in the diagram it shows a "direct" wire connection, but each wire(s) are indicated as being split into (twisted pairs-same AWG) and then back to at each connection end. I think? that there is a connector to do the "wire split", but not sure?
thoughts?

07-21-2020, 06:46 PM	#13
rodstored-72 chevy truck fan Join Date: Mar 2005 Location: Gilbert, arizona 85298 Posts: 1,963	Re: Where do the pedal wires go? Gen IV bigmoe, thank you for the reply. I have the pedal pigtail (about 6-8" long) and the wires from the ECM (per pin nos.) I also have the diagram that shows each end. in the diagram it shows a "direct" wire connection, but each wire(s) are indicated as being split into (twisted pairs-same AWG) and then back to at each connection end. I think? that there is a connector to do the "wire split", but not sure? thoughts?