The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

70inbville · 11-18-2019, 01:59 PM

the 4.8 is complete with all acc needed. I am planning to use a bellhousing from novak transmissions and a sachs1050 flywheel. it has 4:11 in it now and I was going to get around to asking about gearing, so thanks for the answer. The engine ran upside down after a roll over and locked up, so not sure if it is a rod or main bearing and that will direct me further when that is uncovered. I also have a 6.0 sitting in the shop that needs a full rebuild also but like I said earlier I'm worried about the np203. the truck is a bare frame right now and I am just massing a pile of parts and planning.

11-18-2019, 01:59 PM	#5
70inbville Registered User Join Date: Oct 2011 Location: bartlesville ok Posts: 143	Re: 4.8 into 74 3/4 ton 4x4 the 4.8 is complete with all acc needed. I am planning to use a bellhousing from novak transmissions and a sachs1050 flywheel. it has 4:11 in it now and I was going to get around to asking about gearing, so thanks for the answer. The engine ran upside down after a roll over and locked up, so not sure if it is a rod or main bearing and that will direct me further when that is uncovered. I also have a 6.0 sitting in the shop that needs a full rebuild also but like I said earlier I'm worried about the np203. the truck is a bare frame right now and I am just massing a pile of parts and planning.