The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

BR3W CITY · 05-22-2011, 08:17 PM

I headed down to the fab shop today and decided to start on some seat brackets. Grabbed some 1" square tube and made some 17 and 19 inch sections to make a square base.

And since all the good gear is at the shop, I used my favorite welder.. A 40 year old Union Carbide. I don't know why but I weld better with this that anything else.

Ant they fit right into place on the floor

And presto, they are mounted and solid to the floor (used some 5/16 bolts and fender washers with nylocks to spread the load).

I need to get some better pics, but I only had my phone at the time.

05-22-2011, 08:17 PM	#66
BR3W CITY meowMEOWmeowMEOW Join Date: Sep 2009 Location: MKE WI Posts: 7,128	Re: Br3w City's Project omgwtfbbq I headed down to the fab shop today and decided to start on some seat brackets. Grabbed some 1" square tube and made some 17 and 19 inch sections to make a square base. And since all the good gear is at the shop, I used my favorite welder.. A 40 year old Union Carbide. I don't know why but I weld better with this that anything else. Ant they fit right into place on the floor And presto, they are mounted and solid to the floor (used some 5/16 bolts and fender washers with nylocks to spread the load). I need to get some better pics, but I only had my phone at the time. __________________ *'66 Short Step / SD Tuned / Big Cam LQ4 / Backhalfed /Built 4l80e / #REBUILDEVERYTHING* MY BUILD THE H8RDCPTR //\\ MY YOUTUBE CHANNEL REV J HD Last edited by BR3W CITY; 05-23-2011 at 10:23 AM.