[VWNate1]

Very easy : just use one of those tiny little cube relays to switch the power .

I am sure you already know to run the heater element power through heavy wire (the moire strands the better) and FUSE it , power should go from the under hood power tap , to the seat , no where near the dashboard .

-Nate

Originally Posted by Andy4639

Drivers side is installed and wired. Seats move as they should and heaters are working. Got to drive it the rest of the week and see how everything feels and wait for my next night off which is Sunday before I start on the passenger side. I'll have to drill holes for it. The drivers side went good the brackets mounted right back in the same holes as the old seat. Seat belts everything was a easy swap.
I had plan to have the heaters turn off with the seat belt if you unbuckled it and left the switch on but the little wire pig tails in the buckle work in reverse for a buzzer I guess. They will cut off when I turn the truck off but would like to have a safety cutoff if someone forgets. Anybody know a way to do this?