The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - C10CJ: A Pro-touring '71 Stepside on a No Limit Pro-C10 Chassis

1971_c10 · 03-19-2017, 10:43 PM

Got the bulk of the chassis setup complete. The rear end is all buttoned up. Got the 4-link adjusted and set pinion angle to ~2.1 degrees up. I've got the engine set at 3.5 degrees down to give me the minimal interference with the cab at full bump. Unfortunately, that means I need to notch the back of the cab and the rear cross member between the cab mounts. But, the driveline is essentially done. Aside from exhaust and plumbing (brakes/fuel), the chassis is ready to drive. Of course, there is still a good chunk of work left to do before the truck is truly drivable.

03-19-2017, 10:43 PM	#83
1971_c10 Registered User Join Date: Nov 2012 Location: Broomfield, CO Posts: 242	Re: C10CJ: A Pro-touring '71 Stepside on a No Limit Pro-C10 Chassis Got the bulk of the chassis setup complete. The rear end is all buttoned up. Got the 4-link adjusted and set pinion angle to ~2.1 degrees up. I've got the engine set at 3.5 degrees down to give me the minimal interference with the cab at full bump. Unfortunately, that means I need to notch the back of the cab and the rear cross member between the cab mounts. But, the driveline is essentially done. Aside from exhaust and plumbing (brakes/fuel), the chassis is ready to drive. Of course, there is still a good chunk of work left to do before the truck is truly drivable. Attached Images __________________ Chris Build Thread for my '71 Pro-Touring: http://67-72chevytrucks.com/vboard/s...d.php?t=722029 My C10 has it's own facebook page! www.facebook.com/c10cj - it is a public page so no facebook account required to browse through.