[J48chevy]

So I have searched and read most posts about the fun of hood alignment issues. Here is my dilemma. Stock frame and cab, stock hinges, aftermarket fenders and 1 piece hood. As you can see by pics the drivers side is not far off. Thinking if I make holes in cab a little bigger I can get the hood hinge down and back enough to close the gap. The passenger side is another story. As you see in pics this is about an inch off. No way I can move the hinge that much. I have adjusted both using the 4” block in the front and pushing down on the back. This is as close as I can get it. Any suggestions on what to do?