[samwise68]

I'll check out speedwaymotors.com, and see what they have to offer. It really can't hurt. haha.

Here are the pics of my inboard spring mounts:









It's all 1/4 inch plate. Braced, etc. I think I did a pretty decent job, and they'll clean up alright if I choose to grind welds and such.

I'll test fit tomorrow and see how it's all going to work out. Then I'll get my crossmember in for the upper spring mounts, and then decide where the springs lower mount will end up.

And that's it for now...

-Sam.