[Terrysch]

Killer Bee,

Another option for you would be to use these steps from Mike and then modify the underside arms. Extend the arms that mount to the torsion/rocker boxes so the arms mount to the frames. Because the most important part of these vintage look steps are the horizontal steps/platforms.

I am modifying the steps to fit my Jimmy.
Why?
Because I installed a rear sway bar on my Jimmy.
That meant that the dual exhaust that I had installed is routed where the torsion/rocker boxes I have are to be reinstalled. So I am modifying the torsion boxes to go under the rerouted exhaust.
This meant I have to modify the steps I purchased from Mike.
Before I purchased the steps from Mike I reviewed with Dale, a friend of mine who is a fabricator welder guru, to make sure this would work.

Doing this work because I wanted the sway bar for safety, dual exhaust and the vintage look stainless steel steps from Mike.

But for you this does involve getting arm extension stainless steel tubing. Plus you or someone who welds stainless

Pete/DeadheadNM - thank you for calling the rocker boxes torsion boxes. Not everyone understands the true purpose and f