08-18-2023, 03:31 PM
|
#21
|
|
Registered User
Join Date: Dec 2020
Location: Joggins Nova Scotia
Posts: 1,599
|
Re: Rebuilding / Installing Hinge Pillar to Fender Seal
Quote:
Originally Posted by Rich72C10
Got a good match for screws and a so-so "spacer" off Ebay. The spacer is slightly bigger but it will work well enough.
Amazon Prime - pack of 25 for $9.16 shipped
18-8 Stainless Steel Sheet Metal Screw, Black Oxide Finish, Hex Washer Head, Hex Drive, Type AB, #10-16 Thread Size, 1/2" Length
Ebay - Pack of 10 for $10.81 shipped
Specbolt M6x18 Shoulder Washer Motorcycle Plastics Collar Bushings
The top screw/spacer in photo are originals
The bottom screw/spacer are parts listed above
Second photo are some new ones and original staged on the seal. Personally, I think the hole stamping is a bit small.
For the 3rd photo, there is one good hole on my original seals that I have and the "new" spacer sleeve fits snuggly - more or less like the original.
|
looking to me like you've got this figured out.
|
|
|