[Hickup pickup]

Ok Guys "WARNING" These wheels are not for the faint of heart!!!!

I just bought these for my 66 burb. The good- They fit and look great on the rear. The Bad, (I do have disc brake conversion.) In order to make these fit on the front the snout of the rotor will need to be machined down, and not just a little! You will need to find someone who can cone the end of the hub to fit into the two step downs in the wheel , then the fun begins, you will need to trim the spindle down as far as possible and re drill the cotter pin hole. Then you will need to cut the end off the dust cap untill it is a 1/16 from the spindle and then weld a cover (i used a fender washer) to fill the giant hole in the dust cap . next you will need to break off the tabs from the BOSS cap and test fit it over the spindle with the wheel installed,and then silicone it to the wheel, you may still need very thin spacer behind the wheel. If the guy in the pics didnt go through this he must have some other front end like a Camaro or Mustang II. Good luck if you buy these wheels.