Re: Restoring Rusty - Fuel Sending Unit
tried testing the fuel sending unit using the Ohms setting and not sure what the verdict is, sometimes the Ohms changed when the unit was on it's side and I moved the float back and forth, yet when the unit was vertical like it is when its in the tank the multimeter read 1 and did not change when I moved the float up and down
I wired the unit to the truck without the gas tank and turned the key to see what the fuel gauge says and it reads passed Full regardless if the float is almost at the bottom or in the middle or almost at the top, I thought it was a bad ground so I cleaned the rust off of the frame, the bolt, the connections, still no go
no idea what is bad the unit or the gauge or if there is a wire short
Last edited by Gregski; 01-20-2015 at 01:32 AM.
|