[75Dually]

Need some help guys. I started the calibration this evening on the Accuair and it started it just fine, but 30 seconds into the calibration I got a warning that said " Ride height sensor travel warning" So I went to the trouble shooting at the back of the setup manual and it said that the sensor needs to be remounted to a point in the suspension with more travel. I measured everything several times and I have both the front and the rear moving through aprox. 2.5" of travel. So I put the linkage arms to the 2"-3" hole in the arm following the instructions. Have any of you run into this before? If so what did you do to fix it? Any other ideas on what I should be looking for?

Let me know!