Many Drivetrain changes have been made to our trucks over the years.
And now we're making changes and need to get either a different driveshaft, or have ours modified.
In searching these forums I've found that the lengths are all over the place.
So now I'm going to start looking at other vehicles for a donor shaft.
Myself, if I was to keep my ho32, I'd need roughly a 53.75" u joint center to u joint center.
.
So far, from just these forums I've found the following :
.
Quote:
Originally Posted by superwade57
negative on my buddy shortening it.... he said aluminum moves an aweful lot. but i picked up a shaft from a 72 buick sylark, 350/350 and its 54 3/8 c-c on the joints. so i only say this to put the info out there....clip.... .
|