Re: cross sill fabrication
I did & it worked great. You'll need lots of 3" x 2", a bit of 1" by 2" & I put 3 pieces together to make the 3/4" cross member. These measurements are for steel beds. If I could do it again, I would have notched one of the cross members for an under bed fuel tank.
http://67-72chevytrucks.com/vboard/s...d.php?t=138385
__________________
passthebuck
#5642
-TWO 1967 GMC 910's. One with L6/3-on-the tree and the other with 355 w/435hp & a 700r4.
-a 2013 Honda Civic as my "sensible" car
Last edited by passthebuck; 11-10-2011 at 05:38 AM.
Reason: spellin'!
|