|
Re: "Service Airbag"
The most common problems, I've seen with these is the sensors up behind the bumper on the crossmember, and if you take the sill plate, and kick panel off the driver side, I've run into a bunch, that crud and moisture gets down under the sill plate and corrodes the wiring which runs from the sensors to the module under the drivers seat. MIght have to cut out the bad sections and splice in new wire. but make sure to solder and heat shrink to prevent the corrosion again, plain old butt connectors won't protect. But as was said before the best way to pinpoint is a scan tool reading to help youy find the area of the problem.
|