[padresag]

back to the assy illustration on line 75 there shows a sleeve that goes in the rubber hole around the bolt. they may refer to that as a spacer in the writtn descrition. this fills in the differential in sizes. and use shims as required.
I spent a bit of time going back and forth with Michelle911 about putting his/her body back on and got it done and off to the body shop. I asked if they would write a little note about the experience for others but only see silence. it is a one way street for a lot of people

these insulators were superceded several times over the years. as I said previously the square mounts I believe were used in 60-62. the rectangular mount was also used from 67-72 in suburbans but only see a listing for 69-72 for rectangular insulator part # 69-09703(truck and car shop). don't know what happened to 67/68. wonder if that is the same size as the earlier insulators in the 60-66 kit?. that insulator was used for 42 years.
ron