The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Exhaust Exit in front of Axle Questions...

Sinister · 07-19-2002, 10:20 PM

i've been shying away from this one, cause i didn't want to show this old picture of my truck...
looks better now...
i just redid my exhaust, from the headers back,
for about $75... i got the pipes going out under my doors but you could run em out back by the tires...
what i did was bolt some reducers to my headers, they hook right up, leave you with 2.5" pipe, then you get either 45 degree bent pieces or some down turns depending on the angle you want and some straight pipe, then you just clamp it all together, though you could weld it as well...
like i said i ran out under the doors but you can run em further back...
the clamps are cool cause you can change stuff without having to cut pipes etc.

07-19-2002, 10:20 PM	#18
Sinister Between Trucks... Join Date: Mar 2002 Location: Los Angeles, CA. Posts: 3,830	i've been shying away from this one, cause i didn't want to show this old picture of my truck... looks better now... i just redid my exhaust, from the headers back, for about $75... i got the pipes going out under my doors but you could run em out back by the tires... what i did was bolt some reducers to my headers, they hook right up, leave you with 2.5" pipe, then you get either 45 degree bent pieces or some down turns depending on the angle you want and some straight pipe, then you just clamp it all together, though you could weld it as well... like i said i ran out under the doors but you can run em further back... the clamps are cool cause you can change stuff without having to cut pipes etc. __________________ Beat it to fit, Paint it to match...