The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

DrppdBlazr · 04-22-2013, 11:16 PM

Not much of an update cause I only got a couple hours to work this weekend. Got the three back rails all cut and got the two tacked on. Waiting to tack the back on till I can really work on it again so I can make sure everything stays square. Also picked up a VU4 but I think im gonna try and sell it so I can get the New NPT port manifolds accuair just came out with.

just a close up shot of one of the joints

just a shot of the angle of the rails

04-22-2013, 11:16 PM	#79
DrppdBlazr Registered User Join Date: Dec 2012 Location: Mesa, AZ Posts: 276	Re: 79' 2wd blazer Not much of an update cause I only got a couple hours to work this weekend. Got the three back rails all cut and got the two tacked on. Waiting to tack the back on till I can really work on it again so I can make sure everything stays square. Also picked up a VU4 but I think im gonna try and sell it so I can get the New NPT port manifolds accuair just came out with. just a close up shot of one of the joints just a shot of the angle of the rails