Made the transmount out of the old motormount.
First I took it to parts:
Tacked some angled steel to it and bolted it to the chassis.
Then I set the pignon angle and tacked everything together.
I can adjust the transmount by adding shims under the trans itself to get it higher or at the chassis to get it lower, works perfect
Then onto the engine mounts..
I took the old parts of the mount, tacked 3/8" steel to the chassis and the mount.
This is the old part...
This I made from 3/8" steel strip:
Set the engine in the middle of the chassis and tacked the steel:
Made a template and grinded out of the same in 3/8" steel:
And then....I ran out of gas...
But the engine and trans are in!!
What do you think? Strong enough?