[67 chevelle]

Originally Posted by leftybass209

Instead of laughing at what the OP is saying, you can be more helpful and try and answer his questions or not post at all. This forum is designed to be helpful not belittling, you can go elsewhere for that. That's a great way to get new people to leave and not contribute to this site.

there is nothing different mechanically between a normal LS1, and the one that came in the 2002ish Camaro. The only difference is a higher output alternator for the added electronics, and an oil and transmission cooler.

You're asking about an LS swap, which is rapidly becoming a really common thing. There's plenty of references to what people are doing, just try a forum search. Drop the LS1 phrase and just use LS when searching. The blocks are the same and that's the important information you are looking for. The aftermarket has motor mounts, headers, computer interfaces, and all that jazz to make the swap simple. Many members here will have information regarding what radiators work, any clearance issues, or anything else that may come up during the swap.

As MARKTDN said, the LS is drive by wire, so your throttle input merely tells a computer to adjust the throttle body based on a TPS sensor. If you want to run the 700r4, you'd have to switch to a carb setup, which is also readily available for LS engines. You get worse gas mileage compared to FI, but have the potential for more horsepower than a non-turbo/supercharged FI setup.

I have a drive by wire ly6 in my 67 with a 2004r trany , throtle cable is hooked to the pedal , so there are ways to do this , the 700r4 and 2004r use similar throttle position cables